The Butler Didn’t Do it; This time
It took some digging into the Internet, but not too deep really. I didn’t dig too far, not looking for extra organs or hot PPE. The problem was that the print for the X axis stopped at 95% completion and then jumped to 100% complete. I had to plug in the symptoms a few times to get past the COVID-19 stuff and articles, but finally found the answer. It seems that the electronics got too hot from running the extruder motor and therefore shut down before any damage happened to the board.
So the plan now is to load the Purple PLA+ from GST3D.com filament on the older Ender 3(it is just a few months older and less updated hardware/firmware), and knock the infill down to 60% just to be safe. The goal now is to get the project done, because I have bot parts that need to be made. YAY!
Pics or it didn’t happen!
Yes, I have a crappy camera and take sub par pics, but decent equipment costs money. So buy me some Ko-Fi if you would like better quality pics.
Tomorrow, will posting an update on the ‘bot!