It’s been a very busy week, so my free time has been mainly used to rest and plan. Almost prepared for the upcoming shutdown, would be nice if I had gotten the hydroponics going, but yeah 2020.
Just need to wire it up! Just not after a full day. Been reading articles and watching YouTube videos on perceptrons, which are the basic units of Artificial Neural Networks. Which is quite possible the microcontroller pair, mentioned in the previous post.
Made some minor tweaks to the STL, so haven’t printed it in PLA, yet. I figure 20% infill should be enough for it hold the spindle while it’s stationary. I can’t wait to get it all put together, so that I can start investigating what safety measures are necessary such as enclosure type, forced air environment and how much negative pressure is necessary to vacuum up all the copper and fiberglass bits from the work surface, etc. The issue of monitoring spin rate, basically solved itself. The fan is connected to the spindle, therefore they literally spin at the same rate, so a couple of magnets, a hall effect sensor and some decent coding, problem is solved and checked off the list.
I was thinking, a very dangerous thing, that the robot brain would be awesome for managing the hydroponic garden, making it an intelligent plant operator. Okay, that even hurt my head, LOL. Seriously though, the arduino could easily monitor Ph meters, electro conductivity meters and run motors to adjust nutrient and water levels during each stage of a the plants. It would have to still be monitored by a human, but it would require less effort on their part, freeing up time for more down time and be less worrisome.
I Need a Staycation!
Due to the quarantine and the more than likely lockdown in the near future, I can go anywhere I want to, as long as it’s inside head. Actually a few days of sleep sounds awesome.